Ring Size Guide

Whether you are buying the ring for someone else or yourself, you may not know which ring size to purchase. To help you, we’ve prepared a simple guide to determine which ring size will fit your finger.

Whichever method you choose, there are a few basic guidelines to ensure an accurate measure:

• Your ring should fit your finger comfortably: snug enough so that it will not fall off, but loose enough to slide over your knuckle.
• Measure finger size several times to eliminate an erroneous reading.

Please note: Your finger size can change throughout the day, so it is a good idea to measure at the end of the day when your fingers are at their largest. Do not measure when your hands are cold; your fingers will be at least half a size smaller.

2 Popular ways to check the ring size

There are basically 2 popular method of measuring the ring size:

Measure from the existing ring that you or that particular person currently wears. This method, you will get the result in Diameter. 

• STEP 1: Select a ring that properly fits the intended finger.
• STEP 2: Place a ruler with centimeter (cm) or millimeter (mm) indicator on top of the ring and read the value. This measurement refers to the inside diameter of the ring.
• STEP 3: The size you read will be in the range of 13mm to 23mm

Measure from the designation finger.  This method, you will get the result in Circumference.

• STEP 1: Cut a piece of thin string or a ¼ inch wide piece of paper to about 2 inches in length. Wrap the piece of string or paper around the base of your ring finger. Wrap around both the base of your finger and your knuckle if your knuckle is noticeably larger than the base of your finger.
• STEP 2: Mark the string or paper at the exact point that it overlaps to make a complete circle around your finger. Do this for where it overlaps on your knuckle as well, if you needed to measure it.
• STEP 3: Unroll the string or paper and place it against a ruler with millimeter measurements. The length of your measurement is the circumference of your ring finger. If you needed two marks because of your knuckle, make a new mark exactly between the two and use that mark as your measure. Refer to the ring chart above to get your ring size.